!!! CURRENT RELEASE of the 4300 1xRTT AMPS/CDMA/FEX SOFTWARE !!! ---------------------------------------------------------------------- Versions: SCP 5.5, AMPS 5.1, CCMMIC 5.2, CCMDSP 5.2 ---------------------------------------------------------------------- ****** Software Upgrade Notes ****** Thank you for taking this opportunity to upgrade your 4300 1xRTT to the latest version of AMPS and CDMA software. You should upgrade your unit to the current version regardless of whether you are experiencing problems or not. You will find a copy of the installation instructions (the file labeled 4300upgr.txt) in the Disk 1 folder that will be downloaded to your hard drive. Please read the installation instructions carefully as revisions to the procedure may have been made since the instructions were last published. ********************************************************************** ** Downloading and executing the file 4301xRTT54.exe will extract ** ** all software upgrade files to the C:\Temp folder on your PC. ** ********************************************************************** After extraction perform the following: 1) Access the C:\Temp folder on your PC, and copy the files in the DISK 1 folder to a floppy disk. Label this disk "1xRTT System". 2) Copy the files in the DISK 2 folder to a floppy disk. Label this disk "1xRTT CCM". 3) Copy the files in the "Autoruns" folder to your Calibration Disk. These new program sequences will replace the old sequences. The old sequences may or may not function properly with the new software. 4) Now access the DISK 1 folder on your PC, and open the file "431xupgr.txt". Follow the installation instructions. ********************************************************************** ADDITIONAL NOTE: You can verify which options are installed in your 4300 by pressing the key: The Diagnostics - Self-Test screen now displays the options installed in the 4300. If the Option line is blank, then your 4300 is an AMPS only unit !DO NOT INSTALL THE CDMA SOFTWARE! See our web site for the 4300 TDMA software. If IS-2000 does not appear on the Option Line !DO NOT ATTEMPT TO INSTALL THIS SOFTWARE YOU COULD POSSIBLY DAMAGE YOUR UNIT REQUIRING IT TO BE SENT TO WILLTEK FOR REPAIR! See our web site for the 430x CDMA software. If you see DCM-TDMA listed on the option line, your 4300 has the TDMA option installed. See our web site for the 4300 TDMA software. ********************************************************************** If you have any questions about the software installation process or operation of your 4300, please contact the Wireless Technical Assistance Center at 973-386-9696. Email: support.us@willtek.com ---------------------------------------------------------------------- Release History ---------------------------------------------------------------------- Release 5.5 – June 2007 LATEST RELEASE Added support for CDMA - MEID mobiles Release 5.4 – Aug 2004 Improvements in AMPS hardware defect testing Updated Manufacturer’s Code list Release 5.3 – Dec 2003 Minor changes to FER measurements Minor changes to Waveform Quality measurements Updated Manufacturer’s Code list Release 5.2 - May 2003 Service Option 32 (TDSO) testing capabilities added Updated Manufacturer’s Code List Release 5.1 - March 2002 Test Sequence allows testing/identification of 1xRTT capable mobiles Audio Measurement speed increased Willtek Communications, Inc. readme.txt 27 Sep 2004/jaw